Video

Full tutorial, please?

For parallels, A2 tool steel is a good choice. No need to carburize. Heat to 1850F and let soak for about 20 minutes, then let them air cool. Once they get down below about 100F, temper them at 300F for same length of time. Then let air cool again. Hardness should be around 62 Rc. Then grind to size. Makes good parallels.

What steel are you using? Carburizing steels are generally low carbon so they don't get hard except on the surface. The middle stays tough. Steels like 8620, 9310, 4320, etc. But generally, the steel is heated while it's surrounded by the carbon source for hours. Reason I'm asking is because I've seen people carburize medium and high carbon steels and not realize the steel is going to get hard all the way through. (Also, make sure you temper or "draw back" those parts at at least 300F and let air cool or the surface will be too brittle.)

Red hottttt

The procedure is completely useless. To obtain a layer of 0.1 mm, it is necessary to spend 1 hour inside the product at a temperature of at least 880 degrees Celsius. This time that was used will not generate any layer

Good demonstration. Thanks!

Absolutely

Wow this was actually interesting to watch, proper upclose too!!! Thanks for sharing 👍

Big 11k

Tap wrench tutorial next?

good

I’m famous 😌😌

So when is the pedestal expecting

Great stuff

Wow

So good

what should we look for

very helpful content. will defo subscribe!

Making a 26mm hole into a piece of metal on a pillar drill.

✌️ Promo-SM

Who’s the boss?

low ill i

Um. ? My old manual lathe had almost anything tread combo. Better than a die

Nice hachi-roku

Making a screw on the LATHE using a die.

Love it!

A 9 years old boy driving this car 🚗

KNURLING is the process of making patterns on metal for finger grip and style.

TAPER TURNING is done to produce an angular or chamfered surface on a cylindrical piece of material.

Daley is my guy

see i subscribed ‼️

❤️❤️❤️

Good staff

😮😮❤❤

This process is very important when a high level of accuracy is required.

Drilling is the process of making a hole into a piece of material.

Good stuff Carl!!!

Great stuff!

Boring is the process of enlarging a hole already drilled.

Watch to the end ❤

The most complicated equipment I have ever seen.

Watch to the end 😢❤

Please watch to the end

Another masterpiece

where can i buy this?

😮❤❤

good idea ❤️❤️

😂❤😂😅😅😅

Good shit