Video

I love CZcams’s back yard mechanics that had the same issues 2 years ago that you have now! The exact same issue I had!

😂

Bro just Died

What’s if the pin doesn’t pop up ?

❤

Nice

Oh snap. Looks nice.

Awesome thank you 🙏 u the best

1:10 How do you find if you it or not so you don't make that expensive mistake?

Thanks a million 🤘🏽

Thanks it works on 09 lariat

czcams.com/video/MVWHeZLM5oc/video.htmlsi=sa2OxW4k9rYhkHIS this is the first look at my 70 charger my daddy left me. It was his first car when he came from Vietnam and the one i came home in 1976. I am watching your work and inspiration. I will have it in my possession soon for better videos but this was exciting to see after 44 years. I will make him proud. first step is to get it to run then suspension body work thanks again

Nice upload SPF! 👏🏻 Super like #1, comment #1 📌👍 +1 subscriber ✅ Full 35 seconds ads view! 👀 Saw you on Red! 💻 Approaching 1,400 subscribers! 🍀 Have a great week buddy! 🚀

I’m seeing “line” instead of “sync” any advice??

Did you have to remove ac or oil turbo lines

If your door doesn't unlock, how do you open your rear door?

Holy hell you cover alot of stuff

Thats slick

Thanks for this video, my daughter is a mobile groomer and her 9500 on her trailer was having trouble starting, first the choke cable broke ( a bike derail cable will fix that, went to a bike shop, 4 dollars. May have to melt a new end) but that wasn't the only issue, the low oil light would blink while cranking, didn't think much of it, but then it was still having issue of hard start and was randomly shutting down but she never saw a low oil light( I think the sensor got coated with off gassing of oil cause she never changed the oil first 800 hrs🙄) but I just now found the yellow wire, disconnected it and it runs fine now... I also saw a bunch of vids on the CO detection monitor killing the engine. So someone else put out a vid to just duct tape over the sensor... did that also... the thing is always outside, so not worried about that... thought I would post my trouble shooting here... since I found you, others will be looking also... Thanks a million... Hopefully she will not have anymore issues... her mechanic (dad) is tired of working on it...😅

Can it be transported in the trunk of a car?

No yeet???

Im honestly impressed you could get above 25 mph in a ford without breaking something, much less get to the dirt. You must've had it towed there for the video, lol.

Only thing is the truck cost 100,000.00 had to justify.

Honestly, good point. I just like SUVs more because how they look, but sitting in a tank is just the best

I'm 85 k series chevy because I replaced the alternator for 47 dollars and adjusted my valves by ear and started at 8am and was done with the entire project at lunch

That fist shake... lol

Mopar power

Ts is not working😭

Mines just started acting up , turns on but after 10sec turns right off smh

I want to see more stake board tricks

Good video but I can't open it hence the problem...to even get to any of that

Check voltage at the fuel pump connections, also what if you disconnect the fuel and see if it's coming thru?

Doorlock

Awesome! This fixed my super annoying driver side back door that wouldn’t lock. Now my kids don’t set off the alarm every time they try to open the door before I unlock the rest of the car haha. My truck is a 2014 XLT super crew. Luckily, I was able to make the repair without taking to door panel off. Hopefully it holds or I will be back to this video for the door panel removal if it fails. Thank you again for saving me a ton of cash on this repair.

Dude man should have saved the car to hell with the four-wheeler

Thanks..

Got any grapes?

This applies to most EFI vehicles dating all the way back to the 80s 😉

I don't have sync.

About how long did it take you to do this?

Cope and seethe lol

Congrats 💯💯💯

this actually helped a lot thank you so much!

Yeet Yeet 💯💪🏼💯

Ford make good commercials 😂😂😂

No thank you

Been wanting to do this on My 5325 for a long time but wasn’t sure how… Thanks for the video!

Manufacturers do this shit, and this is exactly why I won't buy any of this new garbage. I've never had to "prime" my fucking engine in my 1990s Ford Truck.

Dont buy Ford