Video

Hi Informative New Subscriber

what method is this?

Very useful Information Sir 😮

why here u r multiplying Z% by 10 , could please explain, if anyone else also most welcome

Good use of ai

Very good . .

one of the best

Nice one

Nice

very good video tutorail. simple explanation and easy to understsnd

1:41 thanks for your video, why while calculating z transformer multiple with 10

It's so meaningful and professional classes i would like to join as a mamber please admin

Why did you not consider the contribution of the motors below and the generator above whose ratings are significant????

But you have not considered the incoming grid and generator connected which these will contribute

nice

too complicated , instead do this, first calculate the sec current of transformer, which is Isec= rated KVA/sec voltage, incase its 3 phase (1.73 into voltage) , u will get Isec of transformer, now next step to calculate short circuit current by using the formulae , isc= Isec*100/%imp of transfomer , which will give u the short circuit curent on busbar by transformer

What is 1.05? Pl.describe

Please upload videos on instantaneous current formula

please can you share and update more videos of typical calcualtions of short ckt Transformers and RMU Swithchgears, thanks

MAM WHY CALCULATING Z YOU ARE USING MULTIPLY BY 10

Where did you get 1.05 shown in your cakculation.

but you ignore motor reactance how could you !!!

czcams.com/video/rSQxKJjoGII/video.html

Thanks nice vedio about short circuit study

What is the fault current contribution from motor

Thanks for the video. Please when you mentioned number of runs; did you mean the number of cables or what ? Please, explain it further. Thanks.

Why is the backup generator not included when calculating If at point 2 (Busbar)?

What is value of 1.05

What about motor contributions??

Can you please explain why you are dividing the line voltage by the square root of 3 in Isc formula (At Point 1) ? Your response will be very helpful.

This video really very helpful for electrical engineering interview preparation for freshers and also for experience job seekers. Thank You for this great lecture 🙏

Could you please explain number "10" in the formula for z(transformer). Where did it come from.

Mechanical engineering interview

Please make the video of working principle of induction motor and Faraday laws

This video is very helpful.please make this type of another video

Very nice video. But I did not see any contribution of motors into the fault point as a secondary source and alternator and also why you have included 1.05XV in the calculation?

Explained very nice

and why is that motor contribution is neglected?

why do you have 1.05? does that mean you have increased the voltage to 5%?

❤️❤️❤️❤️

Nice

I feel for Z Tago in formula given instead of 10 we will write 1000.please clarify

Please find explain the formula used

what is the effect of the motors in the short circuit calculation?

How number of runs between point 1 and 2 are 7 ?

Transformer impedance already given %6=.06 ohm so why u are re calculate ?

Good Khonwlede giving All Techanical Staaf.Thank you so much sir

Hi, Thanks for informative video can you please also give the reference for formulas

Medam send video for HT 11KV TO LT 415 V relay coordination method

Medam send video for HT 11KV TO LT 415 V relay