Logan Vlasaty
Logan Vlasaty
  • 36
  • 18 118
BMW e39 M5 front bumper onto 540i and non-M5 e39 models. Umnitza ABS aftermarket
BMW Axial Securing Clip - Genuine BMW 51418201057
BMW Plastic Spread Rivet - OE Supplier 51118174185
BMW Speed Nut - OE Supplier 07129904217
BMW Hex Head Metal Screw - BBR 07119901299
the fog light adapters I ordered were from Amazon and they were called "TOMALL H11 to 9005 9006 Retrofit Wiring Harness for LED Headlight Connector Socket Adapter 12cm(5inch)"...but you can get them from Umnitza for $15 (not $50)
zhlédnutí: 234

Video

Logan's BMW e39 M5T wagon in LeMans Blue
zhlédnutí 587Před 4 lety
2001 525it with a full M5 drivetrain swap from a 2002 M5 donor - S62 engine, Getrag 420g manual 6-speed transmission, M5 driveshaft and differential, M5 brakes w/stainless steel brake lines and yellow painted calipers. The rear air suspension (SLS) is deleted and replaced Einhorn Industries adjustable spring perches with 10k Swift Springs. The exhaust is stock M5 exhaust on the driver's side, a...
I Prevail "Deadweight" live - The Armory, Minneapolis 10.27.19
zhlédnutí 352Před 4 lety
I Prevail "Deadweight" live - The Armory, Minneapolis 10.27.19
E39 headlight adjuster replacement DIY
zhlédnutí 7KPřed 4 lety
This is the "no cut no bake" method, there's another video on CZcams that does a good job showing the removal of the broken adjusters and holders. Hopefully this video helps you get the new adjusters in!
September 14, 2019
zhlédnutí 25Před 4 lety
September 14, 2019
BMW CCA MN Pizza Run #8
zhlédnutí 23Před 5 lety
BMW CCA MN Pizza Run #8
Cruising back roads of Mexico in an e39 M5
zhlédnutí 58Před 5 lety
Cruising back roads of Mexico in an e39 M5
Jeep Grand Cherokee 5.9 Limited
zhlédnutí 72Před 5 lety
Moroso muffler, DT headers, 3" exhaust into stock tips, various other bolt ons.
Blair Walsh from the 3
zhlédnutí 37Před 5 lety
Blair Walsh from the 3
Banff - Tea House to Agnes to Big Beehive
zhlédnutí 68Před 5 lety
Banff National Park, this hike starts at the Lake Agnes Tea House which is about a 1 hour hike from the start at Lake Louise.
Lake Agnes to Big Beehive hike - Part 2
zhlédnutí 188Před 5 lety
Banff National Park
Teahouse to Big Beehive hike - Part 1
zhlédnutí 23Před 5 lety
Banff National Park
BMW e39 M5 vs Eclipse
zhlédnutí 137Před 6 lety
at BIR - PowerCruise 2018
BMW e39 M5 vs turbo Audi
zhlédnutí 112Před 6 lety
Getting walked by an Audi and then running it up to 140mph on the back straight at BIR
BMW e39 M5 vs Mustang GT 5.0
zhlédnutí 1,7KPřed 6 lety
BMW e39 M5 vs Mustang GT 5.0
BMW e39 M5 vs 6.0 Pontiac GTO
zhlédnutí 553Před 6 lety
BMW e39 M5 vs 6.0 Pontiac GTO
011
zhlédnutí 63Před 6 lety
011
2001 540i Touring
zhlédnutí 18Před 6 lety
2001 540i Touring
E39 M5 muffler delete
zhlédnutí 112Před 7 lety
E39 M5 muffler delete
February 8, 2016
zhlédnutí 75Před 8 lety
February 8, 2016
Toby
zhlédnutí 32Před 8 lety
Toby
5.9 open block hugger headers
zhlédnutí 730Před 8 lety
5.9 open block hugger headers
RGB quads for a ZJ
zhlédnutí 208Před 8 lety
RGB quads for a ZJ
ZJ quads wiring
zhlédnutí 43Před 8 lety
ZJ quads wiring
1998 Grand Cherokee 5.9 bolt-ons dyno run
zhlédnutí 532Před 9 lety
1998 Grand Cherokee 5.9 bolt-ons dyno run
Andrews headlights
zhlédnutí 29Před 9 lety
Andrews headlights
RGB ZJ Headlights
zhlédnutí 563Před 9 lety
RGB ZJ Headlights
ZJ relay harness install
zhlédnutí 206Před 9 lety
ZJ relay harness install
98 Jeep Grand Cherokee 5.9L Moroso & E cutout
zhlédnutí 591Před 9 lety
98 Jeep Grand Cherokee 5.9L Moroso & E cutout

Komentáře

  • @isfanalexandru82
    @isfanalexandru82 Před rokem

    i used a heatgun on my 530i e39 2001. you just need to be patient, unscrew the 2 screws next to the signal, then use the heatgun, most on the top, the bottom will follow, and start in the middle and slowly work around left and right. don't use high temp, i used 250 degrees 5-10 cm away of the plastic, and heat it up for 5-6 minutes, then try, then heat up more and try again, maybe heat it up 3,4 times. heat up just the black plastic, not the transparent one. i used a phones opening kit, plastic flat screwdrivers and stuff, not to damage the headlight. on the first one it took me 2 hours, as i didn't knew what i was doing, o the second one it took me 45 minutes to take it all apart 4 pieces, the front the back, the black plastic in front of the mirrors, and the mirrors. take out the rubber seals from the light bulbs slot last, as it will be the last holding point. the motor holds in the bottom middle, unscrew the motor, then hold it, and slide it to the right, while holding the mirrors and slide them to the left. that is a sliding holding point, don't break it and don't pull anything, they are build to be opened fast if you know what you are doing. good luck guys! i might post a vid on how i did it, i have it recorded most of it. enjoy!! P.S. : make sure you have the right parts to replace, non angel eyes have different ones, more straight and more ridges on them mine has factory angel eyes and xenon, choose the right parts

  • @grahamepigney8565
    @grahamepigney8565 Před 2 lety

    Seperating the parts of the headlight unit does make this job a lot easier. I have a variable intensity heat gun and have used that to soften the mastic holding the parts together. You don't need to "bake" the headlight unit. Even if you don't have a heat gun a decent hairdryer will do the job. I got the adjusters from Aliexpress for half-a-dozen euros, enough to repair 4 headlight units.

    • @minn12311
      @minn12311 Před 2 lety

      The problem is that only works on headlights manufactured before 02 something, newer ones are permasealed

    • @grahamepigney8565
      @grahamepigney8565 Před 2 lety

      @@minn12311 not quite true, they are not permasealed. On the facelift(LCI) models (Model Year 2001, Sept 2000 onwards both Xenon and non-Xenon) you can separate the parts. First remove two screws at the indicator end of the unit and then use a heat gun/hairdryer to soften the mastic. Just make sure you only apply enough heat to soften the mastic and not distort the plastic components. There are numerous CZcams videos showing how to do this. I have the various components of my left-hand headlight unit sitting on the bench in my garage waiting for the replacement adjuster pegs to arrive. You can't get the replacement pegs from BMW. I bought 4 sets of pegs (enough for 4 headlight units) from AliExpress for 5.55€ including postage. You can also get the parts on Ebay or Amamzon but it will cost you a lot more. Just make sure that you are ordereing the parts for the facelift/LCI version as the parts for the pre-LCI won't fit.

    • @skellysgarage
      @skellysgarage Před rokem

      @@grahamepigney8565 The headlights produced after 9/2002 are indeed permanently sealed. It is possible to fix them, but you have to dremel the glass off and buy new lenses.

    • @grahamepigney8565
      @grahamepigney8565 Před rokem

      @@skellysgarage The facelift (09/2000 an onwards, no 09/2002 onwards, are all the same). They don't have glass outers they have plastic outers. Realoem and BMW concessionaires confirm this. In fact both pre and post 09/2000 have plastic outers. It is possible to soften the glue holding the plastic outers on by heating the glue and easing apart. How do I know, I have two post facelift E39s and I had to buy a pair of genuine OEM units recently to replace the headlights on one of them.

  • @peterharko5462
    @peterharko5462 Před 3 lety

    I’m going to try this on my January of ’03 build date headlight. Wish me luck.

  • @stignielsen2133
    @stignielsen2133 Před 3 lety

    Thanks. This process may appear impossible at first, but after doing it it's quite "easy"- especially after this video. It took me less than 2 hours for both headlights (my first try). No way splitting the headlights is easier.

  • @Bassalass
    @Bassalass Před 4 lety

    awesome! get my m5t back this month.. cant wait

  • @KKE1978
    @KKE1978 Před 4 lety

    This will help a lot. Thanks. Will tackle this tonight. Pray for me am not so patient.

  • @scarce331
    @scarce331 Před 5 lety

    Link to the headers?

  • @jidana3194
    @jidana3194 Před 5 lety

    M5 ? With that rear view mirror ? I don't know what to tell you

    • @minn12311
      @minn12311 Před 5 lety

      I swapped it out, if you have an M5 you know the oval mirror has less rear visibility.

  • @alexrodriguez9007
    @alexrodriguez9007 Před 5 lety

    Where u buy this headlights

  • @reginald8405
    @reginald8405 Před 6 lety

    I like the Coyote but I love the S62! Thanks for the video.

  • @mackjacobs5489
    @mackjacobs5489 Před 8 lety

    What size halo?

  • @mackjacobs5489
    @mackjacobs5489 Před 8 lety

    What headlight are you using? Spec-D?