460EFIguys
460EFIguys
  • 80
  • 3 686 839
460 EFI Guys low profile throttle body upgrade. It sure didn't run like this before!
We did a full tune-up for this customer before we tested anything. My God, this truck pulls so much harder after. Our test hill is an onramp at 5400 ft of elevation. With no wind, the stock throttle body hit 75 mph. The wind picked up while we swapped on the low profile throttle body. Then, going into the wind, the truck hit 85 mph in the exact same distance.
460efiguys.com
460 EFI Guys Low Profile Throttle Body Kit
zhlédnutí: 2 567

Video

460 EFI Guys Stage 3 cam, 180 degree burnout
zhlédnutí 1KPřed 3 měsíci
460efiguys.com stage 3 camshaft kit performance modified intake low profile throttle body 30 lb/hr accel injectors flowkooler water pump stock bottom end e7te heads
Mike's 460 rock crawler harness and ecu test. Runs awesome
zhlédnutí 135Před 3 měsíci
Mike's 460 rock crawler harness and ecu test. Runs awesome
Kevin's old school bronco
zhlédnutí 128Před 3 měsíci
Kevin's old school bronco
Scott: After years, you can actually drive your your efi 460 truck. Tested great!
zhlédnutí 396Před 5 měsíci
Scott: After years, you can actually drive your your efi 460 truck. Tested great!
460 EFI stand-alone harness. Testing Casey's with E4OD outputs for a usshift controller. Awesome!
zhlédnutí 386Před 5 měsíci
460 EFI stand-alone harness. Testing Casey's with E4OD outputs for a usshift controller. Awesome!
Michael's 460 EFI Bronco II rock crawler build, testing the EFI harness and ecu.
zhlédnutí 155Před 5 měsíci
It's running great pushing this monster around in 4wd.
460 efi guys final test of Timothy's 351C v4 stand-alone system
zhlédnutí 141Před 5 měsíci
460 efi guys final test of Timothy's 351C v4 stand-alone system
460 EFI Guys 532 stroker roller cam build
zhlédnutí 4,3KPřed 6 měsíci
i need to open up the idle holes in the blades for the 532's extra cubic inches. our low profile throttle body. performance modified intake manifold. saginaw coversion powersteering kit. We converted the heads to run a hydrualic roller cam other than that stock f3te heads not ported, Harland sharp roller rockers, deck plate honed, fully balanced including pressure plate, center force dual frict...
460 EFI Guys final testing of the 351 Cleveland EFI stand-alone harness, ecu, and sensors.
zhlédnutí 220Před 6 měsíci
460efiguys.com Came back for us to check everything over due to a stuttering missing problem. We found the brand new MAP sensor was bad.
testing 351 Cleveland 4v components part 2
zhlédnutí 167Před 6 měsíci
I miss spoke they also sent the throttle body for me to test. So far, it's just a bad map sensor. I'm kinda shocked being that's a new Ford part. If anyone is wondering how I'm running a 351 Cleveland harness on my 460, I have jumpers on the injectors to jump the firing orders.
Testing ecu and harness 351 Cleveland 4V
zhlédnutí 122Před 6 měsíci
460 EFI Guys retesting components to find the higher rpm stutter problem. Isolating and testing the harness and ecu with all my sensors to start with. So far, it is solid and crisp. The problem lies with one of the sensors, the coil, or maybe the distributor, but I'll get to the bottom of it.
460 EFI Guys: Rusty's 1977 F-150 out for a test drive. Mild roller-cam EFI 460 engine build.
zhlédnutí 760Před 8 měsíci
460efiguys.com 460 EFI Guys Stand-alone EFI system 460 efi guys swap motor mounts Full turn-key efi engine (performance modified 1993-97 460 build) performance modified intake low profile throttle body Harland sharp roller rockers Factory F3 heads modified for roller-cam Hedman headers for 1993 f350
There is nothing like a efi 460 big block ringing exhuast pipes. Here's a comparison between two.
zhlédnutí 1,3KPřed 8 měsíci
The red truck has dual pipes with flowmaster 70 series (52572) The blue 77 has dual pipes with Thrush mufflers (17659) and a x-pipe
460 efi guys: New version of our revised throttle body for propper downshifts with automatic e4od's
zhlédnutí 1,7KPřed 8 měsíci
460 efi guys: New version of our revised throttle body for propper downshifts with automatic e4od's
460 EFI Guys: Megasquirt EEC-IV ECU. Here's the basetune applied to the flatbed 1994 460. AWESOME
zhlédnutí 2,2KPřed 11 měsíci
460 EFI Guys: Megasquirt EEC-IV ECU. Here's the basetune applied to the flatbed 1994 460. AWESOME
460 EFI Guys. Finishing the base tune of the Megasquirt ecu for Mark's .585 roller cam. AWESOME !
zhlédnutí 527Před 11 měsíci
460 EFI Guys. Finishing the base tune of the Megasquirt ecu for Mark's .585 roller cam. AWESOME !
Bobby K wanted you to hear the old red truck running.
zhlédnutí 445Před 11 měsíci
Bobby K wanted you to hear the old red truck running.
460 EFI GUYS: Rusty's roller motor. Tow spec roller cam. X-pipe with Thrush mufflers over axle.
zhlédnutí 2,6KPřed rokem
460 EFI GUYS: Rusty's roller motor. Tow spec roller cam. X-pipe with Thrush mufflers over axle.
460 EFI GUYS: Garrison's big roller cam full engine build
zhlédnutí 1,1KPřed rokem
460 EFI GUYS: Garrison's big roller cam full engine build
460 EFI GUYS: Finishing and Driving Chris's 460 efi 78 Bronco. stand-alone and USShift controller.
zhlédnutí 461Před rokem
460 EFI GUYS: Finishing and Driving Chris's 460 efi 78 Bronco. stand-alone and USShift controller.
460 EFI Guys: how to run or replace smog / egr vacuum tubes. 7.5 5.8 5.0 4.9 80's & 90's trucks
zhlédnutí 5KPřed rokem
460 EFI Guys: how to run or replace smog / egr vacuum tubes. 7.5 5.8 5.0 4.9 80's & 90's trucks
"ONE WILD BEAST OF A EFI 460" Garrison's roller cam full efi 460 build.
zhlédnutí 6KPřed rokem
"ONE WILD BEAST OF A EFI 460" Garrison's roller cam full efi 460 build.
Finishing testing Jair's ECU. it looks great and runs perfect
zhlédnutí 234Před rokem
Finishing testing Jair's ECU. it looks great and runs perfect
Finally running nice Chris!! Your efi 460 swap 78 bronco has GREAT air fuel curves with this ecu.
zhlédnutí 125Před rokem
Finally running nice Chris!! Your efi 460 swap 78 bronco has GREAT air fuel curves with this ecu.
Chris's Bronco, out tooling around. I wanted to give that ecu one last try before I swap it out.
zhlédnutí 97Před rokem
Chris's Bronco, out tooling around. I wanted to give that ecu one last try before I swap it out.
Connor's harness and ecu testing. This one is very strong even fighting the wind.
zhlédnutí 208Před rokem
Connor's harness and ecu testing. This one is very strong even fighting the wind.
Out testing Julie's 1951 Ford f5 EFI 460 stand-alone harness and ecu. Windy day in the monster.
zhlédnutí 216Před rokem
Out testing Julie's 1951 Ford f5 EFI 460 stand-alone harness and ecu. Windy day in the monster.
Cody's hot rod 460 efi swap harness testing
zhlédnutí 185Před rokem
Cody's hot rod 460 efi swap harness testing
460 EFI Guys: 460 EFI Stand-alone harness. Late night test before it goes out for Kyson's Bronco.
zhlédnutí 186Před rokem
460 EFI Guys: 460 EFI Stand-alone harness. Late night test before it goes out for Kyson's Bronco.