Video

So now you need to have some engine bay work done and the service shop removes the dust cover over the radiator and destroys the light

How much the ambient light

One thing you could do for this car, would be to get some tail light tint spray, then tint the strip darker, so since the light is so bright, it wont have any issue with the tint spray, but since the color of the car is black, the tint spray would color the LED strip black, so you wont see the strip when its off or during the day, it would just look like the hood weather strip piece, but would illuminate when the lights come on. 😁👍

Fun fact the red strip on top is for any weather stripping that your car comes with. For example I have a Crosstrek that has front of hood weather stripping that needs to go on top of these lights.

DUDE IS SOOOOO DUMB!!! NEVER TOUCH MY WIRES!!!!!!!!

How to do the same on Volvo XC90

What about the electrical hook up … anyone can stick the strip on ! 😂

What cleaning spray did this guy use?

One of the best videos I seen. Thanks! This will help me plan my installation better.

qq Is this legal ?

I installed this on my santa cruz and it looks amazing. The blinker function looks slick af and the whole truck just looks menacing as hell coming down the street with the led runners and this strip above them. Never installed something like this before in my life and it took me 15 minutes maybe to clean the surface and slowly line it up after closing the hood a few times to check the positioning. Pro tip for non-dummies: cover the top red tape with black electrical tape. It's not the end of the world. You can get a roll for $1-2. If you are wiring this in yourself you will probably have some anyway.

Gotta take into account the sticky tape was used once, pulled off, and reapplied. You will never get the strip to adhere doing this. Also, you can heat these strips up a little bit to work them around bends. I have also heated the surface and the sticky tape to make it more tacky to go around bends and curves better. Prefit the strip.somyou can be aware just how far the strip will be visible after the install 2nd part center of hood in this vid) and adjust accordingly. Not knocking anything here, just geivign advice.

Oh my stars 😮❤

good video man, helped me out as I needed. I have one question tho, it's advised with the fuzebox to ACC, do you think AC would be a good alternative? It's on anyway by default.

so how long does this last. I heard only last for few weeks then it will be broken

Looks better on the bottom

One day you guys will have another pa customer

Looks dope!! Can’t wait to get mine!!

so glad to be a part of the transformation. came out super FIREEEEE!!!!

My Silverholder LED Strip is way too long (I need a 34-inch) can I cut it without damaging it?

🔥🔥🔥🔥

🔥🔥🔥🔥This shit came out cleeeeaaaannnnn

This looks good 😊

The other side of tape cause u can also put it on the hood direct and depending on side of battery or fuse box give u option to use either side

I installed it on my 2012 jeep liberty and I also added light Windshield Nozzle Washer Wiper. all were blue. everybody tell me my jeep look upgraded to the year.. i ran wire and drill a toggle switch..

I like it idk why u don't like it

Hope you can change the headlights with the housing still in

Yea definitely order new one

Definitely looks like Ludacris' side burns! Need to order the new side skirt for sure! But other than that for the time being doesn't look horrible!

I missed your YT Videos so much glad you finally posted a new video and I think you should just order a new side skirt and you should put bags on your car so you can lift and lower your car so you don’t scrape your car but definitely order a new one but order like 2 or 4 just case you run into the same problems in the future

how would i wire it on 2015 Audi A4 B8, on the amazon listing it saya not to put it to the battery or else its gonna be on till battery drains and due the the fuse boxes being inside the car and one in the trunk any other way i can wire this?

Love itttt

So it just stays on as you are driving? I thought it was just a startup hood beam 🤔

It has tape on both sides because your battery could be on one side and another car could be the opposite side

Possably need to use some painters tape to mount it at first before permanently installing

Answer: just to stick left to right and right to left side purpose. Think on it.

Thank youu!!! Really wasn’t trying to break a brand new car! Your the man

is that road legal in the UK?

Now when you close it. It will stick shut because you removed the tape

The tape on the top in case u want to put it on the hood dummy

The only thing about this install I didn’t like is how you didn’t show how to connect the electrical wires

Sic

Camera man didnt seem certain the installer knew

2:46 use an razor dude

Don't show wiring up just sticking the strip down. 😢

Im guessing The tape is on both sides so you can attach it to the bottom of the hood or the top of the car. As the wires are on one end and need to be near the fuse box, it can’t flipped. The lights are only on side of the strip Im pretty sure.

I see these led stripping is just for looks & show

Never showed it with the headlights

What is he saying that shit look hard

The tape on both sides of the light is so you can flip it over based on battery location