Video

The hard part to find is the actual metal bucket that holds the headlights. If that’s what you talking about I would say find a parts car on fb

After installing both parts I drive about 45 mins. All highway in my way to works some stop and go. I looked down and it was on. Hasn’t come back. Just remember not to overfill the tank. That’s what causes it’s

It works off the obd2 so it should. Any mk6 wheel. Just swap over the trim. Also if it’s dsg order the dsg version.

Well you would need to do the water pump too. If there is no coolant flow ,only 3 bolts and peace of mind. It’s in the pulley side.

What’s the question here sorry.

What won’t go in ? If all the pillars are removed then just put the liner back and start putting the handles first one at a time. And just do the removal process in reverse. Let me know if you need help.

@@NarBrosGaragealright mate I finally managed to get it all back in what a shit way to line everything up 😂🤦🏼

It was leaking. As you can see in the end of the video.

I got a set of Les bulbs from Amazon and the brake one is a flashing bulb.

To make fit perfect you have to cut the mk5 fender and the mk6 and weld it. You can get away with the jsw fender but some body lines don’t line up same with the mk6 fender the body lines don’t line up. I made holes bigger pushed the fender as flush as I could and I liked it so I didn’t care much about the body line. But if it was a show car I wouldn’t to doit right and have it painted too. And cut the mk5 headlight support to put a new place to hold the mk6 support.

They pretty cheap on eBay I think it was like 150 but before the pandemic bro so everything has tripple in price.

Ok thanks bro will check them out on Ebay

Could be done in a couple(2/3) of hours under jack stands. Faster if you have a lift.

Yes these are plastic so you can get it to fit better with big lighter, the ones you use for like food. Head up the corners until they melt(super thick so don’t worry) so fitment is better(mold it ones it’s hot) . Also file a claim they will give you money back if fitment is super bad

are you going to take it out to do it

To be honest with you I wouldn’t be able to tell you. I think that car still has those same coilovers so might not be that bad.

​@@NarBrosGarageok thought it was your car. Thanx

Yes so most universal fog lights come with a relay(not the one on the video) . This one didn’t. So you get the power from the dimmer. You also have two ground. The one by the battery and the one in the actual dimmer. (You only need to slice the wires inside no battery adaptor) that’s to keep it looking oem. (Also the fuse that will blow is the dimmer one) And yes if you like you can use an add a fuse and a different ground. The kit I got came with those instructions.

It’s actually a recall now so if you take it to the dealer they will cover it up to 150k miles and I got all the parts at the dealer around 200 and change for everything. And it’s pretty simple.

@@NarBrosGarage is the recall for a certain year and can you please share the recall details? I have a 2018 Atlas throwing the same code. Ive already replace the purge valve but engine light still present.

⁠@@miltonlopez3260 should be for the vr6 atlas and you can call and give your vin. I think right now mine had 2 recalls. Along with pass side seat sensor. Cel won’t go away if you don’t replace both. Have seen a few people that just replaced the purge valve and it won’t fix it . This is also due to overfilling the gas tank so I would be careful.

@@NarBrosGarage thanks. I did find the warranty number(Number: VWP-23-04). Atlas Carbon Canister Limited Warranty Extension Volkswagen has extended the Warranty coverage for the Carbon Canister to 15 years or 150,000 miles, whichever occurs first, from the vehicle’s original in-service date, for certain 2018-2023 Model Year Atlas and Atlas Cross Sport Volkswagen vehicles.

@@NarBrosGarageI replaced only the purge valve, didn’t work, if you overfilled the tank like me, it is also needing a new canister

Under 300 like 290s for both. From the dealer

Westchester and there is a plug and play version from mk6ix all you need to do is code it

I changed my set up to a vacuum distributor. One end to the manifold and the rest to the gauge, my exhaust, and fuel pressure regulator. As long as there is no leaks everything should work fine.

@@NarBrosGarageok but how was it before i dont know how to do mine, i have a 2013 golf R

@@NarBrosGarage??

Ok so you would need a boost tap. This would go connected by the intake manifold hose and you run that end of the line to this and the other one to the gauge.www.cobbtuning.com/products/turbo/volkswagen-boost-tap-gti-mk6-2010-2014-usdm-2009-2013-wm?gad_source=1&gclid=Cj0KCQjwhtWvBhD9ARIsAOP0GoiyC5KBP9agTkVTjOeXXTjxnAhUkaBVJzoIndzvvk0x12sA0On2SF4aAke8EALw_wcB

as mentioned i have a boost tap but dont i have to t tap into a vacuum line or is boost and vacuum all gonna come out of that one hose that goes to the boost tap? also i have an R not a GTI @@NarBrosGarage

Sadly these suck. I went with a beilstein shock and keep the springs. The shocks went out in a year and a half. And I swapped all my factory stuff over.

Just seen this sorry and did you plug the yellow wire to the right connector on the radio, and made sure that there is power going to the camera ?

thanks... the camera was burn... i returned to amazon and bought another one... is working perfectly, thank u very much

The rca goes on the yellow hole that says camera little diagram (radio side) to the left and the power goes to the radio harness(red wire with the rca). For the rear rca cam wire (on the cable ) And the rear power (wire) and signal (wire) both go to the reverse light. Hope that helps.

@@NarBrosGarage ok ok the both in the same connection.... so.... positive reverse wire , right?

@nelbink2.fernandez (rear of the car camera side) yes both wires from the rca and the camera go to the rear reverse light. The ground goes to that bolt.

and i dont know why a lot of people always put camera power cable in the left reverse light, they need a extra cable to put the rca red wire too. but i they do like u , in the right reverse light is better, i dont know why. and thanks tomorrow will do, i can't finish today

If using the left light, you can use the always on power of the outlet to turn the camera on when drive forward@@nelbink2.fernandez

The main use for these is to give you more track oriented camber. And some coilovers and bags give you adjustment for camber up top. This car didn’t have that style coilover. Only cheap way for him to get the camber ,he was looking for to clear his fenders. And his right height was perfect so he didn’t want to mess with it. He ended up getting bags

Installing is pretty much bolt . This shows how to wire it up .

Remove the 3 bolts from the thermostat housing and just pull it out(easier said than done, I used a piece of wood ). Clean the old part and use new seals and it won’t leak.

Yes headliners are the same.

My best solution would be to get obd11 pro and doit from there. My cable is out of vins and these are very expensive.

@@NarBrosGarage can you help me out I’m already get the obdelevenpro how I can coding the lights ?

⁠@@saulmoreno716 ones you get it go to the same bite as the video and literally follow along. I had a vortex page in Russian when I did the video. Don’t forget to piggy jump the drl. There is a plug and play version from mk6ix he has a different set of coding for his lights i never got around to actually writing everything down. www.mk6ix.com/product-page/10-14-pin-headlight-harness-mk6-pq35

Kw v2 I believe.

@@NarBrosGarage where you get them at

I did this project so long ago they make a plug and play unit now. Mk6ix sells it.

Sadly the basemodel cars don’t support the active driving and drl.

Thank you appreciate it. 💪🏽

El ya no los vende era ruso. Pero pon r32 rear bumper for gti en eBay

@@NarBrosGarage el de eBay tengo que hacer yo los agujeros

@@mood6849 www.ebay.com/itm/175478169416?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=K4iEZ3shS2u&sssrc=4429486&ssuid=hxvh7IGoQzq&var=&widget_ver=artemis&media=COPY

No I didn’t but he also got a different tune now so I’m sure they got around it some how